Signode BXT2 Betriebsanleitung Seite 16
- Seite / 36
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
16
07.09
SIGNODE BXT2
Fig. 6
1
AUTO
MAN.
SOFT
AUTO
MAN.
SOFT
+ / -
+ / -
1
Fig. 8
– Take the tool in the right hand and lift the rocker lever
(6/1) towards the handle.
– Slide the straps, one on top of the other, into the tool
up to the stop.
The strap lead is now approximately 5 cm (2“)
beyond the tool.
– Release the rocker lever.
– Press the tension button (7/1) until the preselected
strap tension is reached. The tool switches over
automatically as soon as the strap tension has
been reached. The straps are welded and the
upper strap cut off.
– The tensioning process can be stopped at any time
and continued again. In order to release the strap
tension after the tensioning process, lift the rocker
lever (6/1) towards the handle.
– The strap tension can be adjusted on the operating
panel (see Chapter 5.6).
Tensioning – welding:
To perform welding before the strap has been tensioned,
fi rst switch to operating mode „Manual“. However, the
tensioning button must be pressed once before welding.
– The digital display (8/1) indicates the cooling time of
the sealing. After fi nishing the friction welding, the
digital display counts backwards (3,2,1). Do not
remove the tool during this time!
Audible signal sounds once:
The sealing cycle is fi nished.
– After the audible signal sounds, raise the rocker lever
up to the handle.
– Swing the tool away from the strapping backwards and
to the right. If the tool is removed too early, the
audible signal will sound several times.
– Check the seal (refer to chapter 5.3).
Never transport or move packaged goods
with incorrectly welded seals.
If the tool is used in a dirty environment, it is
recommended that it should be cleaned daily.
In particular the tension wheel and the tooth plate should
be checked for damage and kept clean. This is best per-
formed by blasting with compressed air (wear goggles).
Fig. 7
1
- OPERATION, PARTS AND 1
- SAFETY MANUAL 1
- ➟ Recharge 3
- ➟ Recargar 3
- ➟ Aufl aden 3
- TECHNICAL DATA 6
- TECHNISCHE DATEN 7
- INFORMACIÓN TÉCNICA 7
- GENERAL INFROMATION 8
- ALLGEMEINES 9
- GENERALIDADES 9
- SAFETY INSTRUCTIONS 10
- SICHERHEITSVORSCHRIFTEN 11
- DISPOSICIONES DE SEGURIDAD 11
- DESCRIPTION 12
- BESCHREIBUNG 13
- DESCRIPCIÓN 13
- ORERATING INSTRUCTIONS 14
- BEDIENUNG 15
- OPERACIÓN 15
- SPECIAL FUNCTIONS 22
- SONDERFUNKTIONEN 23
- FUNCIONES ESPECIALES 23
- WARTUNG UND INSTANDSETZUNG 25
- MANTENIMIENTO Y SERVICIO 25
- Fig. A 32
- 26.06.09 wr/hp 33
- SIGNODE BXT2 34
- NOTIZEN 34
- NOTES NOTES 35
BOXLIGHT DLP manuály
Uživatelské manuály a uživatelské příručky pro Datové projektory BOXLIGHT DLP.
Poskytujeme 2 manuály pdf BOXLIGHT DLP ke stažení zdarma podle typů dokumentů: Uživatelská příručka, Manuál s instrukcemi
Kommentare zu diesen Handbüchern